| Discussion Forum: Thread 359851 |
|
 |
| | | Author: | straightjak1t  | | Posted: | Jul 10, 2024 02:41 | | Subject: | Inventory Change Request for Set 7190-1 | | Viewed: | 42 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Change {18 to 16} Part Dark Gray 3747a Slope, Inverted 33 3 x 2 with Flat Bottom Pin without Connections between Studs
Comments from Submitter:
I just went through and rebuilt my entire set based off of the inventory on here. Following the instruction book I had two dark gray slope pieces left. I counted three times, this set only uses 16ea instead of the 18ea listed on the inventory. Just an FYI, I hope this helps! Have a great day!
|
|
| | | | | |
| | | | | Author: | randyf | | Posted: | Jul 11, 2024 15:44 | | Subject: | Re: Inventory Change Request for Set 7190-1 | | Viewed: | 38 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, straightjak1t writes:
| | Please make changes to the following inventory:
* Change {18 to 16} Part Dark Gray 3747a Slope, Inverted 33 3 x 2 with Flat Bottom Pin without Connections between Studs
Comments from Submitter:
I just went through and rebuilt my entire set based off of the inventory on here. Following the instruction book I had two dark gray slope pieces left. I counted three times, this set only uses 16ea instead of the 18ea listed on the inventory. Just an FYI, I hope this helps! Have a great day!
|
This was a tricky one!
There are indeed 18x
used in the set.
The problem is that two of them are not shown in a parts callout in the printed
version of the instructions, but they are added to the build. This occurs on
Step 29 (first image).
It looks like this was corrected for the version of the instructions that are
currently located from LEGO.com (second image).
Since the inventory is in fact correct, this request will not be accepted.
I have added a note to the set inventory explaining this issue.
Cheers,
Randy
|
|
|
|
|
|
|
|
USA, Minnesota
)
)