Discussion Forum: Thread 254299

 Author: SezaR View Messages Posted By SezaR
 Posted: Jul 3, 2019 15:55
 Subject: Inventory Change Request for Set 854-1
 Viewed: 35 times
 Topic: Inventories Requests (Entry)
 Status:Open
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

SezaR (1475)

Location:  Canada, British Columbia
Member Since Contact Type Status
Jan 15, 2015 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Sezar's trains
Please make changes to the following inventory:
 
Set No: 854  Name: Go-Kart
* 
854-1 (Inv) Go-Kart
206 Parts, 1978
Sets: Technic: Expert Builder

* Add 1 Part 3650a Black Technic, Gear 24 Tooth Crown (1st Version - Not Reinforced) (Alternate) (match ID 4)
* Add 2 Part 3062a Red Brick, Round 1 x 1 Solid Stud (match ID 5)
* Add 2 Part 3673 Light Gray Technic, Pin without Friction Ridges Lengthwise (Extra)
* Change 1 Part Light Gray 3650a Technic, Gear 24 Tooth Crown (1st Version - Not Reinforced) {match ID 0 to 4}
* Change 2 Part Red 3062b Brick, Round 1 x 1 Open Stud {Regular to Alternate} {match ID 0 to 5}
* Change {1 to 2} Part Light Gray 3647 Technic, Gear 8 Tooth Type 1 {Extra to Regular}
 Author: SezaR View Messages Posted By SezaR
 Posted: Jul 3, 2019 16:06
 Subject: Re: Inventory Change Request for Set 854-1
 Viewed: 25 times
 Topic: Inventories Requests
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

SezaR (1475)

Location:  Canada, British Columbia
Member Since Contact Type Status
Jan 15, 2015 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Sezar's trains
In Inventories Requests, SezaR writes:
  Please make changes to the following inventory:
 
Set No: 854  Name: Go-Kart
* 
854-1 (Inv) Go-Kart
206 Parts, 1978
Sets: Technic: Expert Builder

* Add 1 Part 3650a Black Technic, Gear 24 Tooth Crown (1st Version - Not Reinforced) (Alternate) (match ID 4)
* Add 2 Part 3062a Red Brick, Round 1 x 1 Solid Stud (match ID 5)
* Add 2 Part 3673 Light Gray Technic, Pin without Friction Ridges Lengthwise (Extra)
* Change 1 Part Light Gray 3650a Technic, Gear 24 Tooth Crown (1st Version - Not Reinforced) {match ID 0 to 4}
* Change 2 Part Red 3062b Brick, Round 1 x 1 Open Stud {Regular to Alternate} {match ID 0 to 5}
* Change {1 to 2} Part Light Gray 3647 Technic, Gear 8 Tooth Type 1 {Extra to Regular}

Photos are courtesy of the owner of the shop "The Treasure Islan".

This is the very early rare copy of this set as the yellow-black sticker on the
lid says
"Constructional drawings on the back"
As far as I recall, the instructions are placed inside the flap cover in all
copies of technic series 85x.

In my own sealed copy (already sold), there were three gears
 
Part No: 3647  Name: Technic, Gear 8 Tooth
* 
3647 Technic, Gear 8 Tooth
Parts: Technic, Gear
(I did my best to check the content from all angles and was convinced there were
only three, but my copy was sealed anyway). In this copy, there are four of them.
I requested to add the black gear
 
Part No: 3650a  Name: Technic, Gear 24 Tooth Crown - Not Reinforced
* 
3650a Technic, Gear 24 Tooth Crown - Not Reinforced
Parts: Technic, Gear
as alternate as this appeared in only few copies (the set was in market until
the end of 1984), similar to the inventory of the set
 
Set No: 948  Name: Go-Kart
* 
948-1 (Inv) Go-Kart
206 Parts, 1978
Sets: Technic: Expert Builder